lunarbase3dprinting

Building a base on the moon could theoretically be made much simpler by using a 3D printer to construct it from local materials.

The concept was recently endorsed by the European Space Agency (ESA) which is now collaborating with architects to gauge the feasibility of 3D printing using lunar soil.

“Terrestrial 3D printing technology has produced entire structures,” explained Laurent Pambaguian, heading the project for ESA. “Our industrial team investigated if it could similarly be employed to build a lunar habitat.”

According to Pambaguian, ESA’s partners have devised a weight-bearing “catenary” dome design with a cellular structured wall to help shield against micrometeoroids and space radiation – incorporating a pressurized inflatable to shelter astronauts.

Meanwhile, a hollow closed-cell structure – somewhat reminiscent of bird bones – provides a combination of strength and weight. The base’s design was guided in turn by the properties of 3D-printed lunar soil, with a 1.5 ton building block produced as a demonstration.

“3D printing offers a potential means of facilitating lunar settlement with reduced logistics from Earth,” said Scott Hovland of ESA’s human spaceflight team. “The new possibilities this work opens up can then be considered by international space agencies as part of the current development of a common exploration strategy.”

lunarbase3dprinting2

Essentially, 3D “printouts” are built up layer by layer. A mobile printing array of nozzles on a 6 m frame sprays a binding solution onto a sand-like building material. First, the simulated lunar material is mixed with magnesium oxide to turn it into ‘paper’ to print with. Then for the structural ‘ink’ a binding salt is applied to convert the material to a stone-like solid.

Current 3D printers build at a rate of around 2 m per hour, while next-gen designs should attain 3.5 m per hour, completing an entire building in a week.

Read more at www.tgdaily.com

Posted by: Soderman/NLSI staff
Source: Thomas Anderson / http://www.tgdaily.com/space-features/69207-how-to-build-a-lunar-base-with-3d-printing

Share →

SSERVI Science Teams

  • New rock type on the lunar farside found by NLSI Team at Brown/MIT

    2010JE003727(2)

    The farside of the Moon has always been a mystery and is only accessible by spacecraft. New compositional information from the Moon Mineralogy Mapper (M3) onboard Chandrayaan‐1 has identified a suite of highly unusual rock types exposed at small areas within the farside Moscoviense Basin. M3 is a state‐of‐the art visible and near‐infrared imaging spectrometer that was a guest instrument on Chandrayaan‐1, the Indian Space Research Organization’s (ISRO) first mission to the Moon. The instrument is designed to measure accurately the diagnostic mineral absorption bands of solar radiation reflected from the lunar surface.

Inspiration Room

NLSI Inspiration Room

ELS 2014

Did you know?

Water ice and other frozen volatiles are to be found in many shadowed craters near the lunar poles.

Read More